Course Content
TX600 – Training Manual
0/1
TX600 – Commissioning Manual
0/35
TX600 – Spare Parts Manual
The TX600 spare parts manual is a comprehensive guide that provides detailed information about the spare parts used in the TX600 machinery. It includes a parts list, descriptions, illustrations. It is a valuable resource for technicians and maintenance personnel to effectively repair and maintain the TX600 equipment.
0/3
CP440 Portable Motor Training Manual
About Lesson

5.1  Attaching the Handset

In this section the correct procedure on attaching the Handset will be determined.

 

The section refers to a four-control handset, but the same process applies to a two-way and six-way handset.

 

The Pneumatic Handset is attached to the Hoist through the Airline Grommet on the underside of the Hoist as shown in image.

While holding the Airline Connector at the end of the Handset Air Tubes, locate the two small metal ribbed pins with the Airline Grommet on the Hoist. To correctly locate, ensure the profile of the two parts are lining up, this means the grey rib profile, which faces inwards on the Hoist aligns with the grey rib on the Handset, this is the only way the Handset can be connected, therefore it is not possible to incorrectly mate the two parts.

Once the two parts have been aligned, ensure that the Handset is pushed into the Grommet properly, with both metal pins being fully inserted into the Grommet. This is important to ensure there is no air leak which will affect the Hoist functionality.

To remove the handset, follow the procedure above in reverse.