9.3 Batteries
This section will instruct the correct procedure on how to remove and replace the Batteries.
Removal
Step 1 – Remove external covers of the Hoist. (refer to section 9.1)
Step 2 – Disconnect the power lead from PCB. (See section 9.2 PCB for reference)
Step 3 – Release the Velcro straps (arrowed) to give access to the Batteries.
Step 4 – Detach the power cables from the battery terminal. (Arrowed)
Refitting / Replacement
Step 6 – Refitting is a reversal of the removal process noting the following points:
1. Make sure the battery terminal are on the outer edge and the terminals are pointing inwards.
2. Ensure the positive lead (Red) goes to the correct side of the Hoist (Circled) and the negative lead (Black) goes to the correct side of the Hoist (Circled).
3. Ensure Velcro is installed in the below fashion.
