4.2 Battery testing
Within this section it will explain the correct procedure on testing the batteries for servicing procedures or replacement. (To be completed by a competent person)
Step 1 – Take the ACT Battery tester out of the packaging and place on a level surface
Step 2 – take the Lead acid 12v 5Ah battery and locate near tester
Step 3 – Attach the positive connector to the positive terminal in below orientation
Step 4 – Attach the positive connector to the positive terminal in below orientation
Step 5 – Wait for the tester to wake up and ensure to set the machine ‘SET Ah Cal’ to “0”
Step 6 – After it has been set the Tester will show you the battery voltage, ensure this is between 12-13 volts
Step 7 – Press the Red button the start the test
Step 8 – the tester will show a Ah reading, ensure this is above 3.0 Ah
