9.7 Bottom Cover
This section will instruct the correct procedure on how to remove and replace the Bottom Cover.
Removal
Step 1 – Remove external covers of the Hoist. (refer to section 9.1)
Step 2 – Remove QRS Hook. (refer to section 9.6)
Step 3 – Disconnect the power cable from the PCB.
Step 4 – Disconnect the display and LED able from the PCB. (Arrowed)
Step 5 – Gently pull the bottom cover away from the chassis and feed the Lift Tape through to detach it from the unit.
Refitting / Replacement
Step 6 – Refitting is a reversal of the removal process noting the following point:
1. Make sure the lift tape is fed through the slot in the correct direction
2. Ensure the E-lower cord is pulled through its designated slot.
3. Ensure the air grommet lines up with the hole.