9.12.2 – Charging Beak – Track Type 2, 3, 4, 5 and Powered Auxiliary
Within this section it will explain the correct procedure on removing and reinstalling the Charging Beak for servicing procedures or replacement.
Removal
Step 1 – Remove external covers off the Hoist. (refer to section 9.1)
Step 2 – Remove the Battery from the battery brackets. (Refer to section (9.3)
Step 3 – Disconnect the Charging Beak from the PCB.
Step 4 – Reroute the Wire from under the Battery Bracket.
Step 5 – Cut the cable tie that secure the wire to the Chassis.
Step 6 – Using a Pozi Screwdriver, remove the screws to release the Charging Beak.
Refitting / Replacement
Step 7 – Refitting is a reversal of the removal process noting the following point:
1. One cable tie is required! – Re-secure the Wire with cable tie as instructed below:
Pass through the cable tie (100×2.5mm) through the hole and tie to secure the wire to the chassis. Snip the surplus cable once secured.