Course Content
TX600 – Training Manual
0/1
TX600 – Commissioning Manual
0/35
TX600 – Spare Parts Manual
The TX600 spare parts manual is a comprehensive guide that provides detailed information about the spare parts used in the TX600 machinery. It includes a parts list, descriptions, illustrations. It is a valuable resource for technicians and maintenance personnel to effectively repair and maintain the TX600 equipment.
0/3
CP440 Portable Motor Training Manual
About Lesson

8.1  Hoist Removal

The removal of the Hoist is essentially the Commissioning Steps in reversal. A summary of the correct order on how to remove the TX and its components has been listed below. For in detailed information on each of the below steps, see the relevant section within Commissioning for assistance.

1. Turn OFF the Hoist by pulling down the E-Lower Cord to its middle switch.

2. Detach the Carry Bar from the Hoist.

3. Detach the Handset from the Hoist

4. At the end of the Track, remove the End Cap, Safety Bolt and End Stop.

5. Carefully slide the Hoist out of the Track.

6. Turn OFF the Charger at the Wall Socket and remove the plug.

7. Remove the charging unit from the wall using a pozi head screwdriver.

8. Detach and carefully slide the Charger out of the Track.

9. Ensure the End Stop, Safety Bolt and End Cap are refitted to the Track once all the above steps are complete.

10. Hoist Removal is complete.