About Lesson
9.12.3 QRT System Charging Beak
Within this section it will explain the correct procedure on removing and reinstalling the QRT Systems Charging Beak for servicing procedures or replacement.
Removal
Step 1 – Disconnect the Charging Beak from the external cover plug in.
Step 2 – Cut the cable tie that secure the wire to the Chassis.
Step 3 – Using a Pozi Screwdriver, remove the screws to release the Charging Beak.
Refitting / Replacement
Step 4 – Refitting is a reversal of the removal process noting the following point:
1. One cable tie is required! – Re-secure the Wire with cable tie as instructed below:
Pass through the cable tie (100×2.5mm) through the hole and tie to secure the wire to the chassis. Snip the surplus cable once secured.