Course Content
TX600 – Training Manual
0/1
TX600 – Commissioning Manual
0/35
TX600 – Spare Parts Manual
The TX600 spare parts manual is a comprehensive guide that provides detailed information about the spare parts used in the TX600 machinery. It includes a parts list, descriptions, illustrations. It is a valuable resource for technicians and maintenance personnel to effectively repair and maintain the TX600 equipment.
0/3
CP440 Portable Motor Training Manual
About Lesson

9.16  Toggle switch

This section will instruct the correct procedure on how to remove and replace the Toggle Switch.

Removal

Step 1 – Remove external covers off the Hoist. (refer to section 9.1)

Step 2 – Remove the Battery from the battery brackets. (refer to section (9.3)

Step 3 – Remove QRS Hook. (Refer to section 9.6)

Step 4 – Remove Bottom cover from Hoist. (Refer to section 9.7)

Step 5 – Remove the E-Lower Cord. (Refer to section 9.17)

Step 6 – Disconnect the Toggle Switch from the PCB.

Step 7 – Disconnect the Motor wires from the Toggle Switch

Step 8 – Using Snips, cut the cable ties to release the Toggle Switch wires, see image above for guidance on location.

 

Step 9 – Using as small flat head screwdriver, detach the grommet (arrowed) from the chassis by forcing it through the hole.

Step 10 – Pull the Toggle Switch from within the Chassis to remove.

 

Refitting / Replacement

Step 11 – Refitting is a reversal of the removal process noting the following point:

 

1. Cable ties is required! – Reroute the Toggle Switch wires as shown in the image and cable ties into position, cut the surplus once secured.