Attaching the Handset

In this section the correct procedure on attaching the Handset will be determined.

The Electric Handset is attached to the Hoist through the handset port protruding through the bottom cover as shown below.

To attach the Handset, align the groove circled in the image in the same orientation shown. The groove will be perpendicular to the front face of the Hoist.

The Electrical handset is connected to a female connector located on the underside of the hoist.

The orientation of the socket pins – this will only fit into the hoist socket in one position – once aligned press the connection home

When the profile of the two mating parts are aligned. Push the handset connector upward into the port until it is fully located.

To fully secure the handset, twist the threaded lock on the handset connector until it is fully closed.

Perform a brief test to ensure proper connectivity. Turn the Hoist ON and OFF and also use the hand controller to raise and lower the carry bar. If these functions all work correctly, then the hand controller is correctly installed to the hoist.

If the Hoist does not work as expected after connection of the hand controller to the device, then please check firstly that the unit has power to operate. This will be indicated by the LED indicator status on the unit.

To remove the handset, follow the procedure above in reverse.