About Lesson
External Covers
This section will instruct the correct procedure on how to remove and replace the External Covers.
Removal
Step 1 – Use a slotted screwdriver to remove the two brass screws. (Arrowed)
Step 2 – Gently remove the cover away from the Hoist and detach the Wire Ribbon.
Step 3 – Rotate the Hoist 180 degrees and gently position the Hoist in the below orientation. Be careful positioning the Hoist on the Lift Motor.
Step 4 – Using a slotted screwdriver remove the two brass screws from the second cover. (Arrowed)
Step 5 – Gently remove the cover away from the Hoist.
Refitting / Replacement
Step 6 – Refitting is a reversal of the removal process noting the following points:
A. Make sure the profile edge marries up with the bottom and top cover.