Fixing the Charging System

The CP Hoist charging system is designed to charge the Hoist through the Handset.

The charging dock is fitted to the wall, and when not in use, the handset is placed into the dock, and will begin charging. The Hoist cover is fitted with LED’s which will indicate that the Hoist is charging, what stage of charging, or is fully charged.

Follow the procedure below to install the charging system:

1. Remove the charger from the clear bag.

2.Open the small white box and choose the correct plug adapter for the available wall socket.

3. Fit the adaptor to the plug as shown.

4. Choose a suitable location within the buildings wall where the charging dock can be fitted. The wall must be of good structure to fit two screw fixing points. The location must also be close to the pre-installed ceiling track to allow the hoist and the handset to be docked. (Figure 35)

5. Remove the two brown raw plugs and two screws from the small white box.

6. Drill two 7mm holes into the wall that will allow the two given brown raw plugs to be fitted, measure the gap between the two drilled holes to match the profile of the dock.

7. Place the raw plugs into the drilled holes.

8. Align the charging dock fixing point with the holes and use a pozi head screwdriver to fix the two screws and secure the dock to the wall.

9. The mains power supply can now be turned on.

10. The charging dock is ready for use.