Lift Motor

This section will instruct the correct procedure on how to remove and replace the Lift Motor.

Removal

Step 1 – Remove external covers of the Hoist. (Refer to section 9.1)

Step 2 – Disconnect the power lead from the batteries. (For further information refer to section 9.3)

Step 3 – Disconnect the Motor Leads from the PCB. (For further information refer to section 9.2)

Step 4 – Remove the routing of Lift Motor B Wires from under the PCB. (PCB removal is recommended)

Step 5 – Use a 5mm Allen Key to remove the two bolts.

Step 6- Remove the Motor by pulling away from the chassis.

Step 7 – Repeat steps 5 and 6 to remove the opposite Motor.

CAUTION! Motor might be hot.

Refitting / Replacement

Step 8 – Refitting is a reversal of the removal process noting the following point:

A. Ensure the motor aligns with the motor mount tapped holes.

B. Ensure Motor A and B are attached on the correct face. Use the PCB for reference.

C. Re-Route the Motor B Wires under the PCB.

D. Ensure that the Motors are connected into the correct designated port on the PCB.