About Lesson
Removal
Step 1 – Use 1.5mm Allen Key, remove the two grub screws on either side of the Hoist.
Step 2 – Using a 2mm Allen key unscrew the grub screw (arrow) until it releases its hold on the Pin.
Step 3 – Slide the pin out to release the Hook.
Refitting / Replacement
Step 4 – Refitting is a reversal of the removal process noting the following point:
A. Make sure the hole in the QRS pin lines up with the grub screw.
B. Ensure the hook is attached to the lift tape in the orientation above.