Installing the Charging Dock

There are a few variants of charging docks that are suited to different track profiles. But all chargers are installed in the same manner. Follow the instructions below for the correct install method.

1. Remove the safety components found in the track system for access. (Refer to section 4)
2. Align the charger with the rubber bumper facing inwards, towards the track. (See figure 6.1)
3. Place the charging dock into the track and position in front of the safety bolt. (See figure 6.2)
4. Secure the charging dock in the track by clamping the dock together using a 5mm Allen Key on the two bolts. (See figure 6.3)
5. Route the charging cable out through the track profile behind the charger and before the end cap. (See figure 6.4)
6. Refit the safety components behind the charging dock as instructed in section 4. When a charger is installed, this replaces the need for the end stop. Do not install an end stop and charger at the same end of the track.
7. See section 8 for details on installing the charging unit to the wall.