9.17 E-Lower cord
Within this section it will explain the correct procedure on removing and reinstalling the E-Lower Cord for servicing procedures or replacement.
Removal
Step 1 – Remove external covers off the Hoist. (refer to section 9.1)
Step 2 – Remove the Battery from the battery brackets. (refer to section (9.3)
Step 3 – Remove QRS Hook. (Refer to section 9.6)
Step 4 – Remove Bottom cover from Hoist. (Refer to section 9.7)
Step 5 – Use 3mm Allen Key to remove the two M5 x 10 CSK screws. (Arrowed)
Step 6 – Unhook the E-Lower Cord from the Toggle Switch within the Chassis as shown.
Step 8 – The E-Lower Cord can now be removed through the slit in the Chassis.
Refitting / Replacement
Step 9 – Refitting is a reversal of the removal process noting the following point:
1. When inserting the E-Lower Cord through the Slit, ensure the labelled face is facing the Lift Motor.
2. To re-attach the Toggle Switch to the Chassis, you must align the Toggle Switch threaded holes with the holes in the Chassis and attach using the 3mm Allen Key and M5 x 10 CSK Screws.