About Lesson
9.6 QRS Hook
This section will instruct the correct procedure on how to remove and replace the QRS Hook.
Removal
Step 1 – Using a 2mm Allen key unscrew the grub screw (arrow) until it releases its hold on the Pin.
Step 2 – Slide the pin out of the hook to release the lift tape.
Refitting / Replacement
Step 3 – Refitting is a reversal of the removal process noting the following point:
1. Make sure the hole in the QRS pin lines up with the grub screw
2. Ensure the hook is attached to the lift tape in the below orientation.
