9.0 – Servicing – Removal and Replacement
This section will cover the details of how to remove, refit and replace all serviceable parts to the Hoist. The step by step process is to be followed in sequence to perform a successful service on the Hoist. Unless stated otherwise, all images refer to a Mackworth TX600 Advanced with a Standard Wheel Assembly (Track Type 1). Where necessary, additional images for Alternative Track Types have been included.
NOTE: Before carrying out any work on a TX Hoist, remember to switch off the power first. This action can be carried out by pulling on the E-Lower cord once.
When Servicing the TX Hoist, a work bench or table should be used, along with a protective cover such as a cloth to avoid damaging the Hoist. The TX Service Stand is highly recommended to assist during servicing.