9.18 Traverse Idle Gear
Within this section it will explain the correct procedure on removing and reinstalling the Traverse Idle Gear for servicing procedures or replacement.
Removal
Step 1 – Remove external covers off the hoist (refer to section 9.1)
Step 2 – Remove the Wheels from the hoist (refer to section 9.11)
Step 3 – Using a 2mm Allen Key, Remove the M3x12 Screw and M3 Nyloc Nut to release the Traverse Idle Gear.
Step 4 – Split the male and female parts of the Traverse Idle Gear as shown and remove. Ensure to grab the washers placed between each piece of the Traverse Idle Gears.
Refitting / Replacement
Step 5 – Refitting is a reversal of the removal process noting the following point:
1. Ensure when fitting the male and female parts together that the shim washers are still in place.
2. The Female part of the Traverse Idle Gear must be on the same face as the PCB
3. When securing the two gears together, do not overtighten. Once tight, loosen the screw by half a turn to allow the gear ability to rotate freely.