CTH does not raise and lower – High Current - Mackworth Overhead Lift Centre

CTH does not raise and lower – High Current

Print out version available here

In this scenario, the ceiling hoist LCD displays “High Current” and the audible alarm will continuously beep for 3 seconds

Has the ceiling hoist been overloaded during use?(Required)

When the SWL (Safe Working Load) of the ceiling hoist is exceeded, the ceiling hoist will cut power to avoid excessive loading.

Remove the motor from the ceiling hoist but keep it connected to power, use the handset to operate the motor to determine if the gear shaft rotates If the motor is not rotating there has been a gear box failure.

Replace the motor.